Operation - ZUMEX Minex Manual De Usuario

OPERATION

Once the appliance is plugged into the mains at the correct voltage, activate the switch at
the rear of the machine (Fig. 2), and it will be ready to operate.
The machine operates as follows: the oranges on the ramp are automatically introduced
into the extractor system, where they are cut in half and then the juice is extracted by the
drums. Then the juice is deposited in the container or juice jug and the peel in the peel
container.
1
Place the oranges for squeezing on the ramp.
2
Press the ON/OFF button at the front of the machine (Fig. 5), and the unit will
automatically start up the extraction process. This process may be interrupted at any
time by pressing that button again. The machine will also stop automatically a few
seconds after it detects there are no oranges.
3
The dispenser and anti-drip tap allow you to work with the jug inserted in the
machine or with a glass. If working with the jug (Fig. 6A), on extracting the juice, it will
fall into the jug. If you want to serve the juice directly into a glass, remove the jug
and the juice will fall into the juice container. Place the glass under the tap and press
it down (Fig. 6B) to activate the tap. The juice will stop falling as soon as you remove
your finger from the tap. If you wish, you can work with the push button instead of
the jug. Connect the button as indicated in Figure 7. To remove the juice that has
fallen inside the container, push the platform with glass inward, or press the button
flap while you hold the glass (Fig. 6C).
OPERATING MODES AND INFORMATION DISPLAY
The machine may be in the following three operating modes. Depending on the mode
in question, the display will show the following information:
Normal operating mode: The machine is operating or ready to operate. The following
appears on the display:
MINEX
Ct000000 Orange counter
Safety stop mode: The machine has automatically stopped or does not start because
one of the 3 elements affecting safe operation is missing (cover, juice container or peel
container) or because they are not correctly positioned.
The last 2 digits of the 4 on the bottom line give information about the status of each
of those elements. These digits may have the value "0" or "1"; value "0" indicates that
the element in question is correctly position, and "1" indicates that it is missing or not
correctly positioned.
SEG
0010
Juice container (correctly positioned)
Cover and peel container (not correctly positioned)
NOTE:
The values of the first 2 digits give additional information that may be
useful for the machine After-sales service.
19