Temperature / Humidity Sensor; Rain Gauge; Mounting / Placing Of Sensors; Wind Sensor - Oregon Scientific WMR86NSX Manual Del Usuario

TEMPERATURE / HUMIDITY SENSOR

B
1. Press SELECT until the selected area icon
the upper display area.
2. Press / to select channel 1
numerical reading.

RAIN GAUGE

1. Press SELECT until the selected area icon
the lower display area.
2. Press MODE until
3. Tilt the tipping funnel on the rain gauge several times
and verify a numerical reading on the base station.
TIP If no reading is displayed for a sensor, press and
hold SEARCH button on the base station to initiate a
wireless sensor search.

MOUNTING / PLACING OF SENSORS

WIND SENSOR

NOTE The sensor should be positioned in an open area
away from trees or other obstructions.
a
Secure the sensor connector in the desired location:
a. Align the back of the sensor connector to an existing
pole. Secure in place by inserting the ends of the
U-bolt into the holes on the sensor connector and
securing it with washers and bolts.
OR
b. Insert 4 type A screws into the holes of the sensor
connector. Screw firmly into place, i.e., fence.
WMR86NSX_IM_EN R10.indd 6
is in
and verify a
is in
is displayed.
b
Slide wind vane onto the smaller end of the sensor
connector.
IMPORTANT Ensure that the wind sensor is pointing
North to enable it to record accurate readings.
TEMPERATURE / HUMIDITY SENSOR
150cm(5ft)
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
OR
secure the sensor in the desired location using table
stand.
RAIN GAUGE
The base station and rain gauge should be positioned
within an effective range: about 100 meters (328 feet)
in an open area.
The rain gauge should be mounted horizontally about 1
meter (3 feet) from the ground in an open area away from
trees or other obstructions to allow rain to fall naturally
for an accurate reading.
To ensure a level plane:
Put a few drops of water on the cross at the base of the
funnel to check the horizontal level.
6
1
3 2
4
2018/9/20 上午11:52