Connecting An Audio Equipment; Connecting A Set Of Headphones; Connecting An Mp3/Cd Player; Connecting A Computer - Oqan QPD-10 Manual De Instrucciones

Connections

Connecting an Audio Equipment

When using an amplifier, connect the Output L/MONO and R jacks on the
rear panel to the input jack of the amplifier.
Note:
Turn off the power of all devices before you make connections. For mono
playback, use the L/MONO jack.
For stereo playback, connect both L/MONO and R jacks.
The line output volume is controlled by the VOLUME knob.

Connecting a set of Headphones

An optional set of stereo headphones can be connected to the PHONES
jack located on the rear panel of the drum module.
The headphones output volume is controlled by the VOLUME knob too.

Connecting an MP3/CD Player

Connect the audio output of an MP3/CD player or other audio source to
the stereo AUX IN jack on the rear panel.
The input signal is mixed with the drum signal, allowing you to play along.

Connecting a Computer

By connecting a computer to the USB terminal, you can transfer MIDI data
between the module and the computer.
Power Supply & Switch
Connect the power adaptor to the DC IN jack on the rear panel. After
confirming that all connections have been completed, rotate the
volume knob to the left (minimum volume level) before switching the
power on. Press the [POWER] button to turn on the power.
AUTO POWER OFF
The digital drum will automatically turn off the power, if
there is no operation for about 30 minutes.
Press the [START/STOP] button and then turn on the
power to switch off the auto power off function. It will
display "PoF" for a while.
6