Gib Adjustment - Palmgren 30303B Manual De Funcionamiento Y Lista De Piezas

Palmgren Operating Manual & Parts List
ASSEMBLY
Refer to Figure 2.
MODEL 30303B, 3" VISE
• Mount crank handles (Ref. No. 12) to
longitudinal and cross feed screws (Ref.
Nos. 8 and 9) using acorn nuts (Ref. No.
13).
• This vise is shipped with a protective
coating. This coating should be
removed before operation. Remove
protective coating with penetrating oil.
MODELS 30601B AND 30801B,
6" AND 8" VISES
• Thread movable jaw leadscrew (Ref.
No. 14) through end of body (Ref. No.
16) and into hole in movable jaw (Ref.
No. 18).
• Secure with dog point set screw (Ref.
No. 19)
• Mount crank handles (Ref. No. 12) to
logitudinal and cross feed screws (Ref.
Nos. 8 and 9) using acorn nuts (Ref. No.
13).
• This vise is shipped with a protective
coating. This coating should be
removed before operation. Remove
protective coating with penetrating oil.
OPERATION
Refer to Figure 2.
• Mount vise to work surface in desired
location by securing at least two
mounting flanges located on base
(Ref. No. 1).
• Move saddle (Ref. No. 3) by rotating lon-
gitudinal crank handle (Ref. No. 12).
Tighten center set screw (Ref. No. 6) to
secure position.
30303B, 30601B & 30801B
• Move vise body (Ref. No. 16) to desired
position by rotating crossfeed crank
handle (Ref. No. 12). Tighten center set
screw (Ref. No. 6) to secure position.
• Open jaws of vise. Place workpiece
between jaws in desired position.
Rotate vise handle to secure workpiece
between vise jaws. Be sure workpiece is
secure in vise before starting machin-
ing operation.

GIB ADJUSTMENT

• Adjust gibs (Ref. No. 4) by tightening
the set screws (Ref. Nos. 6 and 23) at
each end of the gibs.
• Adjust the screws until a slight drag is
felt when rotating the crank handles
(Ref. No. 12). Tighten nuts (Ref. No. 5) to
secure screws.
MAINTENANCE
Particles of metal or wood can damage
machined surfaces, causing difficult or
inaccurate operation.
• The vise is shipped with a protective
coating. This coating should be
removed before operation. Use pene-
trating oil to remove protective coating.
• Keep machined surfaces and all mov-
ing parts clean and free of dirt, chips
and foreign materials.
• Keep machined surfaces and lead-
screws lubricated with medium weight
machine oil.
3