Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Safety information
The open jaw digit electrical tester
has been designed according to
IEC1010 – 1 and IEC1010 – 2 – 032
concerning safety requirements for
electrical measuring instruments and
hand – held current clamps with an
overvoltage category (CAT III) and
pollution 2.
The open jaw digit electrical tester
complies with the requirements
of the following European
Community Directives: 89/336/EEC (
Electromagnetic Compatibility ) and
73/23/EEC (Low Voltage) as amended
by 93/68/EEC (CE Marking).
However, electrical noise or intense
electromagnetic fields in the vicinity
of the equipment may disturb the
measurement circuit. Measuring
instruments will also respond to
unwanted signals that may be
present within the measurement
circuit.
Users should exercise care and take
appropriate precautions to avoid
misleading.
Symbol explanation
Indicates important safety
information.
Dangerous voltage may be
present.
www.grupotemper.com
Open jaw digit electrical tester
Earth ground.
Double insulation
(Protection class II).
AC – Alternating Current.
DC – Direct current.
Battery.
Conforms to European
Union directives.
Safety precautions
Follow all safety and operating
instructions to ensure maximum
personal safety during the operation
and to ensure the meter is used
safely and is kept in good operating
condition.
• Read these operating instructions
thoroughly and completely
before operating your meter. Pay
particular attention to WARNINGS,
which will inform you of
potentially dangerous procedures.
The instructions in these warnings
must be followed.
• Always inspect your meter and
test leads for any sign of damage
or abnormality before every use.
If any abnormal conditions exist
(i.e. broken test leads, cracked
cases, display not reading, etc.),
do not attempt to take any
measurements.
Instructions manual |
KP 2600
15
Capítulos
Tabla de contenido
