Important - Hyper Tough 8100111 Manual De Usuario

OPERATING INSTRUCTIONS
WET PICK-UP
1. Remove reusable filter and replace it with foam filter when you do wet pickups.
2. This wet/dry vac is equipped with a float mechanism which will rise automatically to cut off the
airflow when the liquid in the tank reaches a predetermined level. When this happens, turn off vac,
unplug the power cord, and empty the dust tank. You will know that the float has shut the airflow off
because the suction ceases and the motor noise becomes higher in pitch due to increased motor
speed. The liquid capacity may vary with the rate of pickup.
IMPORTANT: To reduce the risk of damage to the vac, do not run motor with float in raised position.
Foam Filter
Float in raised position
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental starting, unplug power cord before emptying the dust tank.
1. Remove the power head assembly of the wet/dry vac by pulling outward on the lid clips located
on each side of the vac. Lift off the power head assembly.
2. Dump the tank contents into the proper waste disposal container.
MOUNTING WALL BRACKET
Mount the wall bracket to a wall stud. Secure with hardware provided.
NOTE: An inadequately mounted wall bracket could become loose and fall, causing injury or
damage to the wet/dry vacuum. The location used to mount the wall bracket should be strong
enough to hold the combined weight of the vacuum and accessories.
7