ASROCK 4Core1600-GLAN/M Manual Del Usuario página 16

2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 11)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1: see p.2, No. 17)
(SATAII_2: see p.2, No. 15)
(SATAII_3: see p.2, No. 16)
(SATAII_4: see p.2, No. 14)
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA
HDD power connector
1 6 1 6 1 6
1 6 1 6
ASRock 4Core1600-GLAN/M Motherboard
80-conductor ATA 66/100 cable
These four Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
SATAII_3 SATAII_4
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATAII_1 SATAII_2
data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
power cable to the power
connect to
the power
connector of the power supply.
supply
the red-striped side to Pin1
connect the black end
to the IDE devices