Planning Your System - Ground Zero HYDROGEN Serie Manual Del Usuario

Ocultar thumbs Ver también para HYDROGEN Serie:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Screwdriver
Electric drill, 3 mm / 0.12" carbide drill bit
Mounting screws
Power wire min. 25 mm² / 4AWG
Ground wire min. 25 mm² / 4AWG
Speaker wire min. 2 x 2,5 mm² / 13AWG
As a precaution it is advisable to disconnect the vehicle's battery before making connection
to the +12 Volts supply wiring (see owner's manual of your car for further information).
Please use great caution drilling your trunk. Your gas tank and brake lines can be damaged by puncturing with your drill bit –
this could cause damage or failure of your cars operating systems.
Never pass wires over sharp angles. It is recommended to buffer the power supply of the amplifier with a capacitor min. 1
Farad to guarantee a stable operation voltage.
High powered audio systems in a vehicle are capable of generating "Live Concert" levels of sound pressure. Continued exposure to
excessively high volume sound levels may cause hearing loss or damage. Also, operation of a motor vehicle while listening to audio
external sounds such as; horns, warning signals, or emergency vehicles, thus constituting to a potential traffic hazard. In the interest of
safety, Consumer Electronics recommends listening at lower volume levels while driving.
Before beginning the installation, consider the following:
a.
If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left, and
cooling requirements are met.
b.
If your radio / source is equipped with pre-amp outputs, it is possible to utilize them to drive the amplifier
a.
Select a suitable location that is convenient for mounting, is accessible for wiring
and has ample room for air circulation and cooling.
b.
Use the amplifier as a template to mark the mounting holes, remove the amplifier.
Chose a mounting position where all electric wires are protected from being damaged by sharp edges, heat or other conditions. +12Volt
DC electrical connections must be fused on the battery side. Make sure your radio and all other devices will be turned off while connection
your system. If you need to replace the power fuse, replace it only with a fuse identical to that supplied with the system. Using a fuse of
different type or rating may result in damage to this system which isn't covered by the warranty.
Tools and materials you need
Please note!
WARNING !
equipment at high volume levels may impair your ability to hear

Planning your system

Mounting your amplifier
Warning
- 2 -
Tabla de contenido
loading

Este manual también es adecuado para:

Hydrogen gzha 4200xii

Tabla de contenido