HELPFUL TIPS
CORD LOCATION
•
The cord is located at the base of the unit. Turn base
over and slide door open to remove cord.
ICE CUBES
•
Ice cubes should sit a short while before putting them in the shaving unit. If ice has a
frosty appearance, it is too hard to shave. Let ice sit until it is translucent and wet to the
touch. Then it is ready to put in the Ice Shaving Chamber.
SHAVING ICE
If ice is not shaving, try one of the following:
•
Turn unit off by removing the Lid. Redistribute ice in Ice Shaving
Chamber. BE CAREFUL to avoid contact with shaving blade.
•
Make sure Lid is completely locked in the interlock switch. To start unit,
place the Lid on the unit and turn counter-clockwise to lock in place.
MIXING PADDLE
•
If the Mixing Paddle is not turning, make sure the Pitcher has been turned
clockwise on Base until it stops. The Mixing Paddle must be properly affixed
to bottom of Pitcher and top of unit in order to mix ice and ingredients.
LEAKING
•
It may appear that your FROZEN BEVERAGE STATION is leaking when unshaven
ice melts and drips onto the base. This is normal. Wipe base dry with a soft cloth.
Be sure to use FROZEN BEVERAGE STATION on a water-resistant surface.
CLEANING & MAINTENANCE
1.
After using your FROZEN BEVERAGE STATION, disconnect from electrical
outlet. Remove plug by gripping the plug body and pulling out of
the outlet. Never yank or twist cord to unplug the unit.
2.
Thoroughly wash the Lid, Ice Shaving Chamber, Mixing Paddle and Pitcher in warm, soapy
water. Rinse and dry thoroughly. DO NOT place unit or any parts in dishwasher.
Use EXTREME CAUTION when handling this appliance. Keep fingers clear from
blade and avoid contact at all times when using and cleaning
3.
Use a damp, non-abrasive cloth to wipe exterior Motor Housing, Base and inside of the
unit. Dry with non-abrasive towel. DO NOT put the Motor Housing or Base in water.
4.
Once washing and drying is complete, reassemble your FROZEN BEVERAGE STATION.
Now your FROZEN BEVERAGE STATION is ready to use again.
7