Pelonis FS40-8M Manual De Instrucciones página 4

GUARD & FAN BLADE ASSEMBLY
1. Unscrew and remove the spinner clockwise (or remove
from parts bag) and the plastic nut counterclockwise.
Fig.8. Mount the rear guard against the motor face
so that the pin at the motor face bottom fits through the
tear drop hole in the rear guard mounting ring. When
correctly mounted the set of two tabs on each side of the
motor face will also fit through their designated holes in
the mounting ring, and the rear guard will rest flat and
evenly on the motor face. Fig.7.
2. Mount the Blade set onto the motor shaft through the center hole in the Blade set.
Insert the retaining pin on the motor shaft into the slots in the Blade set core. Insert
the spinner onto the tip of the shaft and turn spinner counterclockwise to secure
the Blade set in place. Fig.9.
3. Open the five latch clips on the rear guard. Align the logo on the front guard so
that it will read horizontally. Insert the edge of the front guard into the fixed clip
at the bottom of the rear guard. Use the five latch clips to secure the two guards
together. Fig.10
Fig.8
OPERATION
1. Speed control knob
Rotate the Speed control knob to start and stop fan and
to change fan speed to 1--Low 2--Medium 3--High.
2. Oscillation Control Button
Push down the oscillation control button on the top of the
motor unit to start fan oscillation from side to side. Raise
oscillation control button back up to stop oscillation motion.
3. Vertical Air Direction
To adjust angle of vertical air direction, grasp the sides of the guard assembly
and lightly push it either up or down.
4. Fan height adjustment
Loosen the Height adjustment ring at the top of the extension pole. Raise or
lower the internal metal pole to the desired height and securely tighten the
Height adjustment ring.
Fig.9
3
Fig. 7
Fig.10
3
2
1
0
Oscillation Control Button