Akai Professional Compressor Guia De Inicio Rapido

Thank you for purchasing the Analog Custom Shop Compressor!
Please read the important notes in this Quickstart Guide to ensure the best possible experience
with your new pedal.
A few notes about power:
Battery:
• To install the included 9V battery, remove the battery cover on the bottom panel of the pedal. Snap
the terminal connector's onto the battery's terminals. Replace the cover, and you're ready to play!
• When using battery power, disconnect your cable from the pedal's input jack when you are not
playing. (The input jack works like an on/off switch for battery power.)
• If you are not going to use your pedal for an extended period, disconnect and remove the battery.
Over long periods of time, batteries can sometimes leak, and their acid or other residue can damage
the pedal. Damage caused by battery leakage is not covered under warranty.
Power adapter (optional):
• To power the pedal with a power adapter, we recommend purchasing the Akai MP9-P6 (9V DC, 300
mA [200 mA minimum], center-negative).
Description:
A compressor effects the levels of your sound. It works as an automatic volume control to
limit the dynamic range of the input signal. The Analog Custom Shop Compressor is a VCA-style
compressor, allowing for some of the widest range of compression available. The pedal's sensitivity control
lets you achieve very subtle leveling and increased sustain.
The controls:
LEVEL: Turn this knob to adjust the pedal's output
volume.
SENS: Turn this knob to adjust how sensitive the
compressor is (how much or how little it compresses
the signal).
BYPASS SWITCH: Step on this switch to turn the
effect on or off. This pedal features a true bypass
switch, meaning your signal won't be colored by the
pedal's circuitry when the effect is off.
QUICKSTART GUIDE (ENGLISH)
Suggested settings:
How you play – your picking style, how heavily you pick/strum, etc. – will determine how you want to use the
Compressor.
If you want a harder "attack" (often used in country-style "chicken pickin'") but also want to maintain the
same volume when the Compressor is off, try setting the SENS knob at the 3 o'clock position and the
LEVEL knob at the 12 o'clock position (shown below).
When experimenting with Compressor settings, make sure you compare your levels when the pedal is on
and off – to ensure you're hearing the change in volume you want (if at all).
Hard attack, no volume change
Notes about signal flow:
Where you place the Compressor in your effects chain will change how it works and influences the sound of
your other effects.
• Placing it before a distortion pedal can make for a great lead sound, both increasing sustain and creating
a more defined "attack."
• Placing it before an overdrive pedal can create a smoother, more consistent overdriven tone, ideal for
solos.
• Placing it after an overdrive pedal will allow for a more dynamic overdriven signal but also let you boost
the overall volume at the end. You'll hear more tonal nuance from the overdrive but also have a
consistent level.
• Experiment with the Compressor's placement in your effects chain. Play around with some new and
interesting tones – and find your sound in the process!
7-51-0346-B
www.akaipro.com