CYBEX gold ATON M + Manual Del Propietário página 46

INSTALLING THE BASE USING A LAP AND SHOULDER BELT
8
Press the Lock-off down until it locks into place.
If the Lock-off does not lock, try loosening the
vehicle belt slightly.
Grab the Base at the Belt Guides and pull from
side to side and front to back to make sure it is
installed correctly. The Base should not move
9
more than 1 inch (2.5 cm) in any direction.
If the Base moves too much, open the Lock-off
and remove a little more slack from the vehicle
belt, close Lock-off and recheck. After this, if the
Base still moves too much, you may need to try
a different vehicle seat location or installation
method, or both.
In most vehicles, you can switch the shoulder
belt retractor into locking mode by pulling out
shoulder belt all the way and then letting it
rewind into the retractor. Pull on the belt to make
sure it is locking.
NEVER install this child restraint using a
non-locking vehicle lap shoulder belt.
46
8
CLICK!
9