Broan Best IS23 Manual Del Usuario página 6

MAINTENANCE
Grease Filters
The grease filters should be cleaned fre-
quently. Use a warm detergent solution. Grease
filters are dishwasher safe.
Remove filters by pushing filters towards the
back of hood and rotating filters downward.
Ductfree Filters
The ductfree filters should be changed every 6 months. Rotate the filters to remove
and replace.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will help
preserve its fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
l
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to
l
avoid water marks.
For discolorations or deposits that persist, use a non-scratching household cleanser
l
or stainless steel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with
l
cleaser and water. Rub lightly in direction of polishing lines or "grain" of the
stainless finish. Avoid using too much pressure which may mar the surface.
DO NOT allow deposits to remain for long periods of time.
l
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
l
to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
l
remain in contact with stainless steel for extended periods. Many of these com-
pounds contain chemicals which may be harmful. Rinse with water after expo-
sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm
water and mild detergent only.
OPERATION
Controls
The hood is operated using the (4) push-
buttons located at eye-level, on the front edge
of the hood.
The light switch turns the halogen lights on
and off.
The blower on-low / off switch turns the blower
on to its lowest running speed. The blower must
be turned on using this switch. Turn the blower
off by pressing this switch a second time.
The blower medium speed switch changes
the blower speed to medium. This switch works only if the blower is already running
at low or high speed.
The blower high speed switch changes the blower speed to high. This switch works
only if the blower is already running at low or medium speed.
The pilot lamp lights up whenever the blower is on.
GREASE FILTERS
LIGHT
SWITCH
BLOWER
ON-LOW /
OFF
SWITCH
- 6 -
BLOWER
MEDIUM
SPEED
BLOWER
HIGH
PILOT
SPEED
LAMP