Setup; Battery Installation; Battery Precautions; Battery Saver - GE 34455 Manual De Instrucciones

Setup

Your universal remote requires two (2) AAA batteries
(not included). Alkaline batteries are recommended.

Battery Installation

1. On the back of the remote, push down on the tab
and pull the cover to remove.
2. Match the (+) and (-) marks on the batteries to the
(+) and (-) marks inside the battery compartment,
then insert two (2) AAA batteries. Be sure to use
fresh batteries.
3. Position the battery cover over the compartment,
then press the top until it snaps into place.
NOTE: If your remote stops operating properly, replace
the batteries with new ones.

Battery Precautions

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Always remove old, weak or worn-out batteries
promptly and recycle or dispose of them in
accordance with local and national regulations.

Battery Saver

Your remote automatically turns off if the buttons are
depressed more than 8 seconds. This will save your
batteries should your remote get stuck in a place
where the buttons remain depressed (e.g., between
the sofa cushions).

Code Saver

You have up to 10 minutes to change the batteries
in your remote without losing the codes you
have programmed.
3