Praher Plastics EO510IND Manual Del Usuario página 21

 the electrical connection must have separating device built into the permanently
installed electrical installation, which enables the disconnection of all electrical
contacts with a contact space of min. 3 mm from the mains. Pay attention that the
supply voltage is correctly protected and an earth-leakage circuit breaker ≤ 30 mA
is installed.
 Only use the equipment in dry rooms, in which no combustible gasses and vapors
are present.
 Do not put the equipment into operation immediately if it has been taken from a cold
to a warm area. The thereby developing condensation water could destroy your
equipment
 If the equipment has visible damages, does not work anymore or has been stored
under adverse conditions for longer periods, then it is to be expected that a safe
operation is no more possible. In this case the equipment is to be secured against
unintentional start-up
and if necessary to be decommissioned.
 Live parts can be uncovered when opening the cover or removing parts. Before an
alignment, maintenance, a repair or change of parts or devices, the equipment must
be separated from all voltage supplies, if opening the equipment is necessary. If
after that an alignment, maintenance or a repair on the opened equipment under
voltage is inevitable, it may only be done by experienced, skilled staff, which has
knowledge of the associated dangers and/or the relevant regulations.
 Capacitors in the equipment can still be charged, even if the equipment is separated
from all voltage supplies.
 Assembly and/or disassembly of the valve only in a pressure-free status (i.e. empty
piping beforehand)
 Valve flow and/or direction of flow must be considered.
Each person involved in the operation and maintenance of the equipment
must have read and understood the present operation manual!
It is for your own safety!
5 www.praherplastics.com