Technical Details - Vetus P8FA Instrucciones De Instalación

Ocultar thumbs

Contenido

página de 9

/ 9
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

ENGLISH

Introduction

Each separate group on the Vetus switch panel type P8F is protected.

Both push-in fuses and automatic fuses (thermal protectors or circuit

breakers) can be used. A range of push-in fuses is supplied with the panel

but automatic circuit breakers must be purchased separately. Each sepa-

rate group may be loaded to a maximum current of 15 A.!!! All 8 groups

together should have a maximum load of 60 A.

The LEDs (light emitting diodes) show which group is operating. The

function labels are fitted with background lighting that can be switched

off. The panel is suitable for both 12 Volt and 24 Volt electrical installa-

tions.

Overloading

If a particular group is overloaded the equipment connected to that

group will be switched off and the LED will go out. The particular group

can be switched on again as follows.

• Set the switch to OFF (O)and solve the overloading problem. Take off

the cap covering the fuses, see diagram 1, replace the push-in fuse

with one of the same value or reset the automatic circuit breaker. Put

the cover with the function labels back on and switch back to ON (|).

Installation

• Fit the panel in such a position that the user can easily operate the

switches and both the LEDs and the function labels can be seen clearly.

The panel is splash proof, class IP64, provided that the cover is fitted

properly over the fuse holder.

• Cut a hole in the instrument panel or a bulkhead using the template

provided, see diagram 2.

• Take off the cover to the fuses and the front plate. Fit the switch panel

using the 6 screws supplied. Use hand tools to prevent overtighten-

ing the screws! Refit the front plate.

Large currents through too thin wires or contact resistances caused

by poor connections can result in wires or connections becoming

very hot and could cause a fire.

• Always connect both plus terminals (BAT + INPUT 12/24V) to a battery

and use insulated (5 mm) eye-bolt connectors.

• Use wire with a sufficiently large cross section, at least 4 mm

• Fit a main fuse, 60 A, in the connection between the battery and the

switch panel, see diagram 3.

• Connect the minus terminal (- GND) directly to the battery or a central

earth strip. Do not use the minus terminal on the switch panel to con-

nect the minus terminals of connected equipment. Use an insulated

(6.3 mm) flat push on cable connector and wire with cross section at

least 0.5 mm

Connect equipment (lights, pumps etc.) to be operated through the

switch panel using connecting wire with sufficiently large cross section, at

least 2.5 mm

, and insulated (4 mm) fork terminal connectors or pin plugs.