Tennsco 1340397 Instrucciones De Montaje Y Manual De Piezas

READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING
TO ASSEMBLE YOUR Tennsco ELECTRONIC WORKBENCH.
DESCRIPTION
Tennsco
electronic workbenches are designed for
electronic assembly, testing, product development and
other uses where access to multiple power outlets is
important. The workbench can use either 30" x 60", 30" x
72" wood tops or 36" x 72" steel tops (see below). Workbench
legs and frames are box formed for strength and rigidity.
Frame front panel has knockouts for four duplex receptacles
as well as a switch and circuit breakers (order optional wiring
kit separately). Removable cover behind receptacle panel
facilitates wiring and prevents contact with rear terminals.
Tennsco
tops are available in a choice of two widths and
two depths and are pre-drilled for mounting to various
workbench bases.
Steel Benchtops (S) are constructed of smooth steel
surfaces, reinforced with channels at each end. There are
no exposed sharp edges or corners. A steel stringer is
included to provide extra rigidity.
Hard Maple Laminate Benchtops (W) are 1
laminated solid hard maple with a smooth oil-seal natural finish.
Plastic Laminate Benchtops (P) are 1
linen, maintenance-free, high pressure non-conductive
plastic laminate over a compressed wood core with a
phenolic backer sheet.
Compressed Wood Benchtops (C) are 1
constructed of tempered hardboard top and bottom surfaces
laminated to a high density compressed wood core. A
smooth, sealed finish gives a durable, non-porous surface.
Available options are listed in the replacement parts list
included in these instructions.
ASSEMBLY INSTRUCTIONS & PARTS MANUAL #1340397
ELECTRONIC WORKBENCH
Tennsco Corp., Dickson, TN 37056-1888 * (615) 446-8000
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE!
⁄
3
4
⁄
5
" thick with grey
8
⁄
3
" thick and
4
Overall Dimensions
All 3072 models .......................... 72"w x 30"d x 33
All 3672 models .......................... 72"w x 36"d x 33
Basic Construction
Steel Top
Top ..................................................12 gauge steel
Reinforcing Channels ......................14 gauge steel
Hard Maple Laminate Top
Top ..............................................Laminated Maple
Compressed Wood Top
Top ........ Hardboard with Compressed Wood Core
Plastic Laminate Top
Top ..............Laminated High Pressure Plastic with
Panel Legs .............................................16 gauge steel
Stringer ..................................................14 gauge steel
Wireway Cover ......................................20 gauge steel
" thick
Receptacle Panel...................................16 gauge steel
Back Panel.............................................16 gauge steel
Options Available:
Side and back rails
Standard and electronic riser
GENERAL SAFETY INFORMATION
Some parts may have sharp edges. CARE must be taken
when handling various pieces to avoid injury. For safety,
wear a pair of work gloves when assembling or performing
any maintenance on workbench.
SPECIFICATIONS
Compressed Wood Core
Lower Shelf
Stackable Drawer
⁄ 1
"h
2
⁄
1
"h
2