Troubleshooting - BE QUIET! PURE POWER L8 Manual Del Usuario

Make especially sure that no cables get caught in the components and damage
them.
Installing your new be quiet! Pure Power power supply:
1. Place the new power supply in the space provided in the case and mount it to the
rear with the four screws provided. Do not use excessive force.
2. Plug the 20/24 pin connector into the socket provided on the motherboard. If
you have a 24 pin connector, put the remaining 4 pins in the right position before
plugging the connector into the socket. If using a 20 pin connector, simply leave
the additional 4 pins on the side.
3. Now connect the 4 pin connector, also called the P4 connector, into the socket
provided on the motherboard. This connector is going to supply your PC with
additional power.
4. If required, plug the PCIe connector to your graphic card.
6.

TROUBLESHOOTING

Please note:
In ATX systems, the power supply receives a signal from the motherboard when
switched on, without which it cannot run. For this reason, please ensure that the
power switch connector (usually located on the front panel) is correctly connected
to the motherboard using either the motherboard or case manual. If this is the
case, check the power (on/of) switch, as it may be faulty which means the power
supply cannot be started. You can use the reset switch instead of the power switch
in order to avoid such faults.
Careful!
Working on power sources could lead to serious injury. You must read item 2 –
"Warnings and safety instructions" carefully. Repairs must only be carried out by
authorised technicians!
If the system does not function properly with the power supply installed, irst
check the following possible sources of faults:
8