Setting The Maximum Brake Performance - Carson MODEL SPORT DRAGSTER SHOOTER 6SL Instrucciones

10. Setting the Maximum Brake Performance

Flashing
frequency
Brake
performance
(%)
• Press the SET button down until the blue and green LEDs light up.
Release the SET button again.
• The blue and green LEDs start flashing. This shows that you are in the
mode for setting maximum brake performance.
• Press the SET button repeatedly until you reach the required setting.
The blue and green LEDs flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
CARSON DRAGSTER Brushless Controller
1 2 3
10 20 30
4 5 6
40 45 50
7 8 9
55 60 65
10
70
GB
35