Preventative Maintenance Kits; Service Intervals - Parker BAC-4015 Guía De Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

4 Preventative Maintenance Kits

4.1 Service Intervals

Component
Complete Assembly
Filtration
Filtration
Filtration
Filtration
(1) Unlike oil aerosol removal filters which are changed annually to guarantee compressed air quality, the lifetime of an oil vapour removal filter can be attributed to
various factors and require more frequent changes. Factors affecting the lifetime of adsorption filters are:
Oil vapour concentration - The higher the inlet concentration of oil vapour, the faster the activated carbon capacity will expire.
Bulk oil - Adsorption filters are designed to remove oil vapour and odours, not liquid oil or aerosols. Poorly maintained or non-existent pre-filtration will cause the OVR filter capacity
to quickly expire.
Temperature - Oil vapour content increases exponentially to inlet temperature, reducing element life. Additionally, as temperature increases, the adsorption capacity decreases,
again reducing element life.
Relative Humidity or Dewpoint - Wet air reduces the adsorptive capacity of the carbon.
Compressor oil changes - When compressor oil is changed, the new lubricant burns off "light ends" which increases the oil vapour content for hours or even weeks afterwards.
This increase in oil vapour content is adsorbed by the OVR filter, significantly reducing its adsorptive life.
ACS / AC Element performance is based upon a maximum oil vapour inlet concentration of 0.018mg/m
PDP.
These elements should be replaced upon detection of vapour, odour or taste.
(2) Under normal operating conditions the HC cartridge should be replaced every 12 months. If an oil vapour incident occurs then we recommend that the AC and HC
stages are replaced at the same time
Key:
Check
8
Description of Service Required
Operation
Check for air leaks.
Check the pressure gauges during purging for excessive back
pressure.
Replace the adsorption filter elements - Activated Carbon
Recommended Service
Replace the adsorption filter elements - Hopcolite
Recommended Service
Replace the coalescing filter elements and automatic drains
Recommended Service
Service recommended every:
(1)
(2)
3
, with compressed air at 21
Replace
See Note (1)
See Note (2)
o
o
c and a pressure dewpoint of -40
c
Tabla de contenido
loading

Tabla de contenido