Ryobi RY31EP26 Manual Del Operador

OPERATOR'S MANUAL
Telescoping Pole
RY31EP26
DANGER:
To reduce the risk of injury, the user must read and understand this operator's manual as
well as the operator's manual for their pressure washer before using this product. Failure to
follow all warnings and precautions may result in death, serious personal injury, or property
damage.
IMPORTANT SAFETY WARNINGS
n Keep at least 50 feet away from power lines. Do not touch or aim spray at electrical wiring
of any kind.
n Do not extend or retract the telescoping pole or change nozzles or accessories while spray-
ing or while the wand is under pressure. Turn off the pressure washer, shut off the water
supply, point the nozzle in a safe direction, and pull the trigger to release water pressure
before making any changes.
n Do not use the telescoping pole while on a ladder or scaffolding.
n When using the telescoping pole at any position less than fully extended, make sure the
high pressure hose is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress. Keep the hose clear of the working area.
n Do not exceed the maximum rated pressure, volume, or temperature listed in the product
specifications.
n Do not remove or alter any warning labels included on the telescoping pole.
n Before beginning operation, make certain the area you plan to work in is clear of obstruc-
tions or hazards.
n Maintain proper balance and control of telescoping pole at all times.
n To minimize the risk of kickback, grip the telescoping pole firmly with both hands. A firm grip
together with a stiff arm will help you maintain control of the telescoping pole if kickback
occurs.
PRODUCT SPECIFICATIONS
Connections ...........................M22 Inlet, 1/4 in. Quick Connect Tip, Threaded Accessory Port
Adaptor .................................................................... Female M22 x 3/8 in. Male Quick Connect
Length ...................................................................................................... 5 ft. extends to 16 ft.
Maximum Pressure ..............................................................................................up to 4200 psi
Maximum Water Flow ......................................................................................................8 GPM
Maximum Water Temperature .......................................................................................... 140°F
ASSEMBLING THE TELESCOPING POLE AND BRUSH ACCESSORY
See Figures 1 - 3.
To assemble the telescoping pole:
n Open the lock levers on each section of the telescoping pole.
n Place the center sections of the telescoping pole into the opening on the trigger handle sec-
tion, starting with the largest diameter piece and ending with the smallest diameter piece.
Close the lock lever on each section once installed.
LOCK
LEVERS
LOCK
LEVERS
TRIGGER
HANDLE
POLE
SECTION
Fig. 1