Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Aux In
R/M/L Switch
DC IN 12V
Remote Control
Installation
Transmitter
1. Plug the included AC/DC adapter into a standard wall outlet.
2. Insert the adapter connector plug firmly into the DC IN jack located on the rear panel of the
transmitter base, OR
3. Insert 4 „AA‟ alkaline batteries (not supplied) in the battery compartment and close the
battery door. A blinking BLUE light on transmitter indicates drained batteries.
4. Extend the retractable audio cable located on the back panel of the transmitter and connect it
to the output jack of virtually any audio source.
Note: Do not fully extend the cable until ready to retract.
5. To retract the cable, pull it until it is fully extended and then allow it to feed back into the
base.
6. If the audio source device has red and white audio out RCA jacks use the included RCA to
RCA cable to connect the device to the transmitter. Plug the RCA cable into an open AUX
OUT port on the back of your receiver, or plug directly into your TV set. If the RCA cable
is used the retractable cable is not connected to any device and should not be extended.
Battery Compartment
Power ON/OFF
Mood Light
Volume Up/Down
Rear View
Tabla de contenido
