Heath Zenith 6190 Serie Manual De Usario página 2

WARNING: To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
Figure 1
Figure 2
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screwdriver
(see Figure 1). See diagram inside push button
for correct battery orientation. Note: If battery is
preinstalled, remove orange battery tab.
2. Test range. Temporarily position push button
where you want it mounted. Press push button
to verify chime and push button work properly. If
chime does not sound, see Troubleshooting.
3. Mount push button. Use either screws or double
sided tape to mount push button.
• Screw Mounting: To mount with screws, re-
move back of case by pushing in tab on bottom
with a small screwdriver (see Figure 1). Note:
Remove material in screw holes (if needed)
before mounting with screws. Attach back of
case to door jamb or wall (see Figure 2). Snap
front of push button on.
• Tape Mounting: When attaching push button
using double sided tape, make sure the surface
of the door jamb or wall is clean.
-2-
595-5507-12