PumpSpy PS1000 Instrucciones De Instalación Y Funcionamiento página 7

LED STATES
POWER
SYSTEM
DATA
INFORMATION CENTER LCD MESSAGES
System OK
Power Fail
Backup On/Pwr OK
Hi Water in Pit
Main FS Stuck On
Backup FS Stck On
Voltage Low
Voltage Critical
Primary Hi Amps
System Error
Sig Strgth:xx
Start Autotest
Reading Battery
Data > Host
Host Data Valid
ALARM MUTE BUTTON
• Clears the alert message displayed on the information center LED
• Silences the alarm for 24 hours
© PumpSpy Technology, LLC Questions?
Green AC Power is on
AC Power not available
Red
Green No current alerts
Red One or more alerts are active
Green Blink System is connected to PumpSpy Remote Monitoring Service
Red Blink System is NOT connected to PumpSpy
Displayed when no alerts are active.
Displayed when no alerts are active.
Displayed when backup pump cycles with AC power available for primary pump. (Possible main pump failing)
Displayed when high water float sensor is triggered.
Displayed when primary pump runtime exceeds normal value.
Displayed when backup pump runtime exceeds normal value.
Displayed when battery voltage drops below 11.4 volts (50% discharged)
Displayed when battery voltage drops below 10.4 volts (90% discharged)
Displayed when primary pump current exceeds baseline amp reading by 50%
Displayed when alarm for an alert is muted.
Display of signal strength as read from cellular module (press mute button)
Displayed when PumpSpy Monitoring Service initiates a system test
Displayed when unit measures battery voltage during self test
Displayed when system sends alert or self test results to PumpSpy
Displayed when valid command is received from PumpSpy
Call Tech Support: 515.999.6935