connecting: Hd HERO2 + Remote
With the Wi-Fi BacPac attached to an HD HERO2 camera, you
can wirelessly connect, one-at-a-time, to a Wi-Fi Remote,
Smartphone, Tablet or Wi-Fi Network. The Wi-Fi Remote
gives you control of up to 50 GoPro cameras simultaneously.
Your Wi-Fi BacPac and Wi-Fi Remote arrive pre-connected in
the Wi-Fi Combo Kit. Follow the steps below only to connect
additional HD HERO2 cameras with Wi-Fi BacPac's to your
Wi-Fi Remote or to a new Wi-Fi Remote.
1. Put your Hd HERO2 into Connection Mode:
a. Make sure your Wi-Fi BacPac is attached to your
HD HERO2 camera and both are powered ON.
b. Short press the POWER/MENU button on the
Wi-Fi BacPac to enter into the HD HERO2 Wi-Fi
Menu Screen.
c. Press SHUTTER/SELECT to enter into the Wi-Fi
Connection Menu.
d. Using the POWER/MODE button, highlight New
WiFi RC. Then press SHUTTER/SELECT.
e. The Wi-Fi connection animation will appear
indicating that the Wi-Fi BacPac is searching for
a connection. Press SHUTTER/SELECT at any
time to cancel.
f. Proceed to next step.
56
connecting: Hd HERO2 + Remote
2. Put your Wi-Fi Remote into Connection Mode:
a. Ensure the remote is powered OFF
b. On the Wi-Fi Remote, hold down the SHUTTER/
SELECT button while powering it ON.
c. Release the SHUTTER/SELECT button when you see
the connecting screen on the Wi-Fi Remote.
3. If the connection is successfully made,
you will see the following screen on both
camera and remote
After, you will be asked if you would like to connect
to additional cameras, press the SHUTTER/SELECT
button to select YES, then repeat step one above.
Otherwise select NO.
4. If connection was not successful, you
will see this screen. Please repeat the
steps above.
The Wi-Fi Remote can control up to
50 GoPro Cameras (Original HD HERO
TIP:
and later) at a time from up to
600ft / 180m away.
57