Display Panel; Overview Of The Display Panel; Display Panel Operation - Core BH Manual

EN
USER MANUAL

4. DISPLAY PANEL

4.1 Overview of the Display Panel

Central Display Panel with a screen located in the centre of the handlebar, with a remote control located on the
left side of the handlebar:
1. POWER button.
2. Pedal assistance mode indicator colour.
3. Battery level indicator.
2 3
Mando Remoto
NOTE

4.2 Display Panel Operation

4.2.1. Switching the Pedal Assistance System On and Off
The pedal assistance system is turned on by holding down the POWER
button for 1 second. The pedal assistance system is turned off by holding
down the POWER button again for 1 second.
The bicycle can be used normally without any type of assistance.
WARNING
NOTE
28
1
The range is calculated based on the riding conditions during the last
kilometre and the remaining capacity of the battery.
After turning the system on, make sure that you do not start riding without
checking the assistance mode. By default, it starts with the assistance mode
selected before it was last switched off.
Wait for 3 seconds after turning on the system before you start applying
pressure on the pedals. During this 3-second period, the assistance system is
starting up and calibrating the torque sensor. Otherwise, if you press the pedal
beforehand, this may weaken assistance and error 14 may even be displayed
on the screen (see Troubleshooting section). To fix this, you should reboot the
system without applying pressure on the pedals for a period of 3 seconds.
CORE
1 sec