Electrical Requirements; How To Set Up Your Desk Fan - Fanimation BREEZE FP6274 Serie Manual Del Usuario

ELECTRICAL REQUIREMENTS

Table fan requires a grounded electrical supply line of
120 volts AC, 60 Hz, 15 amp circuit. 8 ft power cord
included. NOT for Damp Location Use.
1. Carefully remove from package. Plug cord
directly into the electrical outlet. (Figure 1)
2. Select the desired airflow, located on top of fan
by rotating switch clockwise. (Figure 2)
The switch speeds are as follows:
0 = Off
1 = Low
2 = Med
3 = High
3. Pull up on the oscillating knob for non-oscillating
operation. Push down on the oscillating knob for
oscillating operation. (Figure 3)
4. Turn the tilt angle adjusting knob on the fan's
neck to the left to loosen and hold the fan head
to adjust up and down to the desired tilt angle.
Turn tilt angle adjusting knob to the right to
tighten the fan head once your fan is at the
desired tilt angle. (Figure 4)
Electrical Requirements

How to Set Up Your Desk Fan

▲WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
80°
Oscillating
Figure 3
3
Figure 1
Figure 2
30°
Figure 4