Tabla de contenido
Step 7
Slide the FEET (31E and 32E) into the notches in the SKIRTS (Q and R).
å
Use a hammer to drive a PROPEL NUT (14M) into the holes in the
å
FEET (31E and 32E). Now, turn an ADJUSTABLE GLIDE (18E) into each
PROPEL NUT as shown in the upper diagram.
Fasten the SKIRTS (Q and R) to the BOTTOM (F2). Use four BLACK
å
9/16" WAFER HEAD SCREWS (33S) through the FEET and into the
BOTTOM as shown in the lower diagram.
NOTE: You should start each SCREW a few
å
turns before completely tightening
any of them.
32E
31E
R
R
BLACK 9/16" WAFER HEAD SCREW
(4 used for the FEET)
www.sauder.com/services
32E
31E
R
Q
This hole must be here.
F2
Q
R
33S
18E
(4 used)
14M
422427
LARGE DOOR ON LEFT
Page 13
Tabla de contenido
