Rejuvenation The Falcon Manual Del Propietário página 7

How to Assemble Your Ceiling Fan (continued)
5. 5. Route wires through motor coupling cover,
canopy screw cover and ceiling canopy. (Figure 5)
6. Reinstall the hanger ball on the downrod as
follows. Route the two 80 in. wires through the hanger
ball. Position the pin through the two holes in the
downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9
inches above top of the top of the downrod. Strip
insulation off 1/2 inch from the end of each lead
wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
Secure the three blades using the 1/4˝-20 screws
8.
with blade plate throug
bottom of the motor assembly (marked A-A, B-B, C-C).
(Figure 8)
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
h the holes located on the
Ceiling
Canopy
Motor
Coupling
Cover
1/4˝-20 Screw
w/Lock Washer
(2 each per blade)
Blade Plate
Motor
Assembly
1/4˝-20
SCREWS
7
Canopy Screw
Cover
Figure 5
Figure 6
Figure 7
Blade
(not included)
Figure 8
HARDWARE USED:
x 6