Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PRECAUTIONS, RESTRICTIONS AND WARNINGS
Precautions and warnings "during the installation" of quipment
- The equipment should only be installed by Saevo authorized technical assistance or
technicians.
- Check that the socket in which the device will be connected has a ground connection.
According to the ABNT standard, this is essential for the safe operation of the system;
- Position the equipment in a place where it will not get wet.
- Install the equipment in a place where it will not be damaged by pressure, temperature,
humidity, direct sunlight, dust, salts, or sulfur compounds.
- This equipment was not planned for use in an environment where vapors, anesthetic
mixtures infl ammable with air, or oxygen and nitrous oxide can be detected.
- Check the voltage of the equipment at the moment of executing the electrical installation.
- The equipment must be grounded correctly.
- This equipment must be installed so that it is level.
- Before the first use and/or after long interruptions from work such as vacations, clean
and disinfect the equipment.
Precautions and warnings "during the use" of equipment
- The equipment should only be operated by duly enabled and trained technicians (Dental
Surgeons, Capacitated Professionals)
- If any maintenance should be required, only use services of the Saevo Authorized
Technical Assistance.
Saevo shall not be responsible for:
- Use of the equipment differing from that for which it is intended.
- Damages caused to the equipment, the professional and/or the patient by the incorrect
installation and erroneous procedures of maintenance, differing from those described in
these. Instructions for use which come with the equipment or by the incorrect operation of it.
The sealing bar operation temperature bar is very high. Watch out not
to touch it directly.
Precautions and warnings "after" the use of equipment
- Turn off the main switch of the dental set when it is not in use for an extended period of time.
- Always maintain the equipment clean for the next operation.
- Do not modify any part of the equipment. Do not disconnect the cable or other
connections without need.
- After using the equipment, clean and disinfect all the parts which may be in contact
with the patient.
Precautions and warnings during the "cleaning and disinfection"
of equipment
- Before cleaning the equipment, turn off the main switch.
- Avoid spilling water, or other liquids inside the equipment, which could cause short circuits.
- Do not use microabrasive material or steel wool when cleaning, or employ organic solvents
or detergents which contain solvents such as ether, stain remover, gasoline etc.
30
Tabla de contenido
