Cooper Security 726r Manual De Instrucciones página 6

Testing.
1. Put the control unit into engineer walk test.
2. Hold the detector in place.
3. Trigger the unit.
4. Make sure the panel receives the alarm.
5. Check that the control unit can receive the signal from the PA across the whole
site.
6. Put the control unit back into user mode when you have finished testing.
Specification
Part No.
Power Supply
Temp. Range
Power Supply
Battery Life
Service
The battery is permanently soldered in place on the PA's circuit board. When the battery
fails return the unit to the manufacturer.
If the transmitter shows a pulsing glow from the activity LED for 30 seconds then a fault
has occurred. Return the unit to your supplier.
726rEUR-60 (without aerial)
726rEUR-50 (with aerial).
Lithium cell.
-10 to +55 °C.
Lithium cell permanently soldered in. Return to Cooper Security
Service Department for replacement.
3 to 5 years.
6