Battery Charge - Panasonic KX-TCA120EX Manual De Instalación

TCA120EX(EX).book Page 6 Wednesday, February 16, 2005 11:50 AM
• Charge the battery(ies) in accordance with the information provided in this
installation manual.
• Only use the included base unit (or charger) to charge the battery(ies). Do
not tamper with the base unit (or charger). Failure to follow these
instructions may cause the battery(ies) to swell or explode.
Connections
• The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)

Battery charge

Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show "Please Wait..." when the handset is
placed on the charger if it is not registered to a base unit.
Registering the handset to KX-TCD200 base unit
Ensure that the handset is switched on. If it is not on, press and hold
for few seconds to turn the handset on.
{ih}
1
Lift the handset and press
2
Press and hold on the base unit for about 3 seconds, until the
{x}
registration tone sounds.
3
Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and stops flashing.
w
Note:
• If an error tone sounds, or if
manually. (See manual registration in the KX-TCD200 operating
instructions.)
• If all registered handsets start ringing in step 2, press
again from step 1.
• Charge the batteries for about 7 hours before initial use.
6
to put the handset in standby mode.
{ih}
is still flashing, register the handset
w
{x}
to stop. Start