Tabla de contenido
FIG. 6
6) Slide the Top (H) over the tower assembly so that the Cam Connectors (K) go into the holes in top
edge of Left and Right Side Panels (A & D) and dowels go into the shelf dividers and left and right
vertical dividers.
Insert Cam Housings (L) into the holes in side panels and tighten.
FIG. 7A
FIG. 7B
7) Turn unit face down on a clean protected surface; measure from top left to bottom right
from top right to bottom left
is longer, tap bottom of side at
side at
until measurements are equal.
Place bottom edge of backs flush with bottom edge of tower assemblies and centered side to side.
Attach Backs (J) to the tower assemblies using #6x5/8" Philtruss Screws (N) in all the predrilled
holes in the backs except for the lowest outside hole. On these holes, attach a Mending Plate (O)
using the #6x5/8" Philtruss Screws (N). See FIGURE 7B.
Attach two Pads (P) to the bottom of the Side Panels and Vertical Dividers.
8) Install the Adjustable Shelf (T) at the desired location using the Shelf Brackets (R). See FIGURE 8A.
Attach the shelf to the shelf brackets by screwing a #6 x 3/8" Brass Screw (S) through the bottom
of the shelf bracket into the shelf. See FIGURE 8B.
9) Secure hutch to desk using #6x5/8" Philtruss Screws (N) in the other holes of the mending plates.
PAGE 6 – 637W
K
A
N
N
N
N
N
N
J
/ . The measurements should be equal. See FIGURE 7A. If line
, until measurements are equal. If line 3/4 is longer, tap bottom of
L
J
N
637W
Hutch
O
636W
Desk
N
H
K
L
D
FIG. 8A
R
FIG. 8B
S
T
/
and
/
Tabla de contenido
