WALL MOUNT INSTRUCTIONS (CONT.)
Caution: When mounting the 209HR, ensure that the mounting location is free of electrical
lines, gas pipes, and other safety hazards. Ensure that wall can support the 209HR.
Note: Do not mount the 209HR on a door.
Determining the Mounting Location:
The height rod channel can be mounted on the wall at any height, based on intended usage. Mount
the height rod channel lower on the wall for pediatric use or higher on the wall for use with adults.
Guidelines for determining the base line location of the height
rod channel are shown below. The height rod may be mounted
with the bottom of the device anywhere from 21.7" - 37.4"
(55 cm – 95 cm) from the floor.
Desired Maximum
Height Measurement
78.7" / 200 cm
maximum height available
63" / 160 cm
pediatric use only
Wall Mounting Instructions:
1. Determine the location on the wall where the
height rod will be mounted. While holding the
height rod channel at the determined
location, using a pencil or screw, mark the
wall at the base line and in the nail hole at
the top of the height rod channel.
2. Remove the lining paper from the double
sided adhesive tape at both ends of the
height rod channel and affix the height rod
channel onto the wall. To secure the height
rod channel on the wall use either the
included nail and flower cap or one of the
screws. Insert the nail or screw through the
hole at the top of the height rod channel and
into the wall. Place the flower cap onto the
nail head.
NOTE: Do not use a magnetic screwdriver.
Base line Location
(Distance from floor to
bottom of height rod)
channel)
37.4" / 95 cm
(distance from floor)
21.7" / 55 cm
(distance from floor)
5
Base Line
Measureable Range
95 cm / 37.4" 100 – 200 cm / 39.4" – 78.7"
85 cm / 33.5" 90 – 190 cm / 35.4" – 74.8"
75 cm / 29.5" 80 – 180 cm / 31.5" – 70.9"
65 cm / 25.6" 70 – 170 cm / 27.6" – 66.9"
55 cm / 21.7" 60 – 160 cm / 23.6" – 63"
Base line should not exceed
37.4" / 95 cm from the floor.