Troubleshooting; Specifications - LG C251 Manual Del Usuario

Troubleshooting

Symptom
No power. • The power cord is disconnected.
The power is on, but • No disc is inserted.
the DVD player does
not work.
No picture. • The TV is not set to receive DVD
signal output.
• The video cable is not connected
securely.
No sound. • The equipment connected with the
audio cable is not set to receive DVD
signal output.
• The power of the equipment connected
with the audio cable is turned off.
• The AUDIO options are set to the
wrong position.
• An unplayable disc is inserted.
The DVD player does
not start playback.
• The rating level is set.
• The remote control is not pointed at
The remote control
the remote sensor on the DVD player.
does not work properly.
• The remote control is too far from the
DVD player.

Specifications

General
Power requirements: AC 110-240 V , 50/60 Hz
Power consumption: 6W
Dimensions (Approx.):
225 x 43 x 208 mm (8.8 x 1.6 x 8.1 inches)
(W x H x D) without foot
Net Weight (Approx.): 0.77 kg (1.7 lbs)
Operating temperature:
5 °C to 35 °C (41 °F to 95 °F)
Operating humidity: 5 % to 90 %
Outputs
VIDEO OUT:
1.0 V (p-p), 75 Ω, sync negative, RCA jack x 1
COMPONENT VIDEO OUT:
(Y) 1.0 V (p-p), 75 Ω,negative sync, RCA jack x 1
(P )/(P 0.7 V (p-p), 75 Ω, RCA jack x 2
B R
AUDIO OUT:
2.0 Vrms (1 KHz, 0 dB), 600 Ω, RCA jack (L, R) x 1
Note: Design and specifications are subject to change without prior notice.
P/NO : MFL36431076
Possible Cause
DIGITAL OUT (COAXIAL):
0.5 V (p-p), 75 Ω, RCA jack x 1
System
Laser:
Semiconductor laser, wavelength 650 nm
Signal system: NTSC
Frequency response:
DVD (PCM 96 kHz): 8 Hz to 44 kHz
DVD (PCM 48 kHz): 8 Hz to 22 kHz
CD: 8 Hz to 20 kHz
Signal-to-noise ratio:
More than 90 dB (ANALOG OUT connectors only)
Harmonic distortion: Less than 0.02%
Dynamic range:
More than 95 dB (DVD/CD)
Accessories:
Video cable (1), Audio cable (1), Remote control (1),
Batteries (2
Correction
• Plug the power cord into the wall outlet
securely.
• Insert a disc.
• Select the appropriate video input
mode on the TV.
• Connect the video cable securely.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
• Turn on the equipment connected with
the audio cable.
• Set the AUDIO option to the correct
position, then turn on the DVD player
again by pressing POWER.
• Insert a playable disc. (Check the disc
type and regional code.)
• Change the rating level.
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control closer to
the DVD player.
)
21