Idiomas disponibles
Idiomas disponibles
MCD 203 Series
English
1
Mounting – mm (inch)
2
Dimensions – mm (inch)
3
3
Wiring
A
Main Contactor
6 A @ 30 VDC resistive / 2 A 400 VAC,
AC11
7
Adjustments
A
Initial Torque
8
LEDs
Ready
– Off
No control power
– On
Ready
– Flash
Starter tripped
Trip Codes
Ready
Description
x1
Power Circuit: Check mains supply L1, L2, L3; motor circuit T1, T2, T3; and soft
starter SCRs.
x6
Supply Frequency: Check supply frequency is in range.
x8
Network Communication Failure (between accessory module and network): Check
network connections and settings.
x9
Starter Communication Failure (betwen starter and accessory module): Remove
and refit accessory module.
Disconnect from the power source before installing or servicing.
Always apply control voltage before (or with) mains voltage.
With 24 VAC/VDC use contacts rated for low voltage and low current (gold flash or
similar).
This product has been designed for Class A environments. Use of this product in
domestic environments may cause radio interference.
4
4
A
2 Wire
C
Close then open N2 to reset a trip
5
Cable Termination
75 ° C Wire - Use copper conductors only.
6
Specifications
Power Rating
A
Mains Supply
B
C
Control Supply
B
Ramp Up
Run
Motor not running
Motor running at full speed
Motor starting or stopping
MG.17.J2.7K – VLT is a registered Danfoss trademark
B
3 Wire
C
No soft stop
Motor will coast to stop.
