GX 75 (US) - GB Seite 5 Dienstag, 27. März 2012 3:04 15
Pay attention that persons are not harmed by
sparking. Remove combustible materials in
the direct area. Sparks develop when grinding
metals.
The workpiece must always lie securely on the
grinding rest and the stop. Workpieces that are
too small or too thin may not be worked. Dan-
ger of injury from workpieces being thrown
from the machine.
Never touch the running grinding belt.
Danger of injury.
Press the safety switch immediately in danger
situations. The machine runs on for up to
50 seconds.
1.4 Emission values for sound (Two-figure – specifications as per ISO 4871)
Sound emission
A-weighted emission pressure power level measured at the
workplace L
(re 20 μPa), in decibels
pA
Measuring uncertainty K
Measured A-weighted sound power level L
ibels
Measuring uncertainty K
Operating conditions
Speed (rpm)
Material
Dimension
Grinding belt
REMARK: The sum of the measured emission value and respective measuring inaccuracy
represents the upper limit of the values that can occur during measuring.
Wear ear protection!
Measured values determined in accordance with the corresponding product standard.
Clean the ventilation slots of the machine reg-
ularly. The motor fan draws dust into the hous-
ing. Excessive accumulation of metal dust can
cause electrical dangers.
Pull out the mains plug for maintenance and
repair! Switching the machine on unintention-
ally can lead to serious injuries.
Have the electrical safety of the machine
checked regularly in accordance with statutory
regulations. For machines that have not been
checked, there may be danger of electrical
shock!
Make sure that you or other persons are not
standing directly next to the grinding belt when
switching the machine on. The grinding belt
can tear apart and cause serious injuries.
, in decibels
pA
(re 1 pW), in dec-
wA
, in decibels
wA
en
5
Idle
Grinding
81
93
4
4
91
100
2.5
2.5
3000
3000
–
ST 37
–
8 x 40
– Slugger 36Z