Battery Installation - Sovereign S-22-DGP-E-S Instrucciones De Instalación

IMPORTANT:
Your safe is delivered with a Safety
Interlock Screw which must be removed
in order for you to lock your safe.
Failure to do so will compromise the
safety and security of your safe.
First open the safe by turning the handle clockwise
and pulling the door open.
Locate the Safety Interlock Screw on the side of the
door; unscrew with a Phillips screwdriver, remove
and discard the screw.
Your safe can now be closed and locked. Do not
lock your instruction manual and/or keys in the
safe. You will need this manual for the instructions
on locking and unlocking the safe.
Safety Interlock Screw

BATTERY INSTALLATION

You must rst install the ba ery which is located in
the ont protective styrofoam.
NOTE: When changing the ba ery, always hold
the ba ery connecting cap while disconnecting or
a aching the ba ery. Do not pull on the wires.
Doing this could cause the power supply to become
disconnected from the lock.
is safe uses one 9V alkaline ba ery. Under normal
use the ba ery will last about 1 year.
When the ba ery is low and you press a bu on on
the keypad, a red light will come on warning you
that the ba ery is low.
To test the ba ery, enter your security code. If the
ba ery is low the red light will come on
momentarily.
To replace the ba ery, remove the cover by pressing
the tab and turning the cover as shown in the
illustration. Replace the old ba ery and screw the
cover back in place.
TAB
2
18
40664-1511