Intermec 1015CP01S Manual Del Usario

CN51 Mobile Computer Compliance Insert
Model 1015CP01S
For Users in English-Speaking Regions (en)
Product documentation is available at www.honeywellaidc.com.
Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future
reference.
Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories
other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the
compliance of this product and may result in the loss of the user's authority to operate the equipment.
Battery, Charger, and Power Supply Information
Caution: For use with Intermec battery pack Model 1015AB01 only. See battery instructions. For power supply, use Intermec Model
1015AV01, AE37, or AE36. No user-serviceable parts.
Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic materials if
mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from
children.
802.11 Radio Precaution Statement
Caution: Users are responsible for configuring the channels of operation that comply with their country regulatory standards. A
Wireless Network Administrator should review the operating restrictions detailed within the Access Point installation manual.
Radiation Exposure Statement
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,
Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European
Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.
If a body worn accessory is not purchased from Intermec, the accessory must contain no metal and provide a 1.00 cm (0.39 in) space between
the device and the body.
Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits
established for this equipment.
For Users in the U.S.A. and Canada
Imager and Camera Flash Compliance and Precaution
The 1015CP01S is registered with the CDRH as a Class II LASER Product (21 CFR Subchapter J, Part 1040). This product has a maximum
output of 1 mW at 630-680 nm.
This product complies with IEC 62471:2006-07 for LED safety.
This product may use any of the following Intermec scan engines:
• EA30
• EA31
The camera assembly with flash is classified as: Risk Category 2.
Caution: When using the camera flash, keep the camera flash LED at least 317 mm (12.5 in) away from the subject's eyes. Otherwise
serious damage to one's eyes may occur.
Caution: There are no user serviceable parts inside the 1015CP01. Use of controls or adjustments, or performance of procedures
other than those specified herein, may result in hazardous laser light exposure of up to 1 mW at 630-680 nm.
Note: There are no controls or adjustments provided for routine operation or maintenance of the 1015CP01S.
NTC
Type Acceptance
ESD-GEC-1302204
1