Idiomas disponibles
Idiomas disponibles
Before using your new Steren´s product, please read this instruction
manual to prevent any damage.
I M P O R T A N T
The instructions of this manual are for reference about the product.
There may be differences due to updates.
Please check our website (www.steren.com) to obtain the latest version of the
instruction manual.
•
Clean with a soft, dry cloth.
•
Do not expose to extreme temperatures.
•
Before use, always test the voltage detector on a known live circuit to verify proper
operation.
H I G H L I G H T S
Your new voltage detector allows you to verify the AC voltage in an easy and safe way.
Quickly detects voltage at control wires, outlets or conductors from 100 to 240 V ~.
Compact design for an easy handle.
Use two type AAA batteries.
Caution
C A U T I O N S
S Y M B O L S
Double insulation or reinforced insulation
B A T T E R Y I N S T A L L A T I O N
1. Open the end cap by gently prying up/out at the pocket clip
using a small flat screwdriver.
2. Insert two new or with enough charge AAA batteries paying attention to polarity.
3. Replace the end cap.
A C V O L T A G E D E T E C T I O N
1. Put the voltage detector near to the energy line (around 0.5 cm).
2. If AC voltage is present and correct, the detector light will flash and the audible
warning will sound.
The conductors in electrical cord sets are often twisted. For best results, rub the
probe tip along a length of the cord to assure placing the tip in close proximity to
the live conductor. The detector is designed with high sensitivity. Static electricity
may randomly trip the sensor.
S P E C I F I C A T I O N S
Input: 3 V
(2 x AAA)
Voltage sensitivity: 100 a 240 V ~
Frequency: 50 / 60 Hz
Detection distance: 0.5 cm
Over voltage: Cat III 600V
Safety: For indoor use and in accordance
with Over voltage Category III, Pollution
Degree 2.
Product design and specifications are subject to change without notice.
