Generator Storage - Firman RD9000E Manual Del Propietário

8. STORAGE

Generator Storage

The following procedures should be followed prior to storage of your generator for
periods of 3 months or longer.
Drain fuel from fuel tank carefully. Gasoline left in the fuel tank will eventually
deteriorate making engine-starting difficult.
Loosen the drain screw on the bottom of the carburetor float chamber, and drain the
fuel completely.
Change engine oil.
Check for loose bolts and screws, tighten them if necessary.
Clean generator thoroughly with oiled cloth. Spray with preservative if available.
NEVER USE WATER TO CLEAN GENERATOR.
Pull starter handle until resistance is felt, leaving handle in that position.
Store generator in a well ventilated, low humidity area.
Generator Battery
This product is equipped with an automatic battery charging circuit. The battery
will receive charging voltage when the engine is running. The battery will maintain
a proper charge if the unit is used on a regular basis (about once every two weeks).
If it is used less frequently, the battery should be connected to a trickle charger or
battery maintainer to keep the battery properly charged. If the battery is not able
to start the engine, it can be started by manually pulling the engine recoil cord. If
the battery voltage is extremely low, the charging circuit may not be able to
re-charge the battery. In this case, the battery must be connected to a standard
automotive style battery charger for re-charging before it can be used.
Disconnect the Battery
1. Remove the protective cover from the black/negative battery lead.
2. Disconnect the black/negative lead from the black/negative terminal on the battery
and store the cap screw and nut.
3. Repeat steps 1-2 for the red/positive battery lead.
4. Store the battery in a cool, dry place.
DRAIN
SCREW
Page 26