Features; General Instruction - Target MCC 75E Instrucciones De Operación Y Lista De Piezas

MANDATORY
WARNING
PROHIBITION
These signs will give
advice for your safety
Before leaving
machine is thoroughly tested.
Follow our instructions strictly and your machine
will give you long service in normal operating
conditions.
1.

Features

Use: Dry sawing of concrete or pavement.
Tools: Diamond blades -- dry only
Ø: 6 - 8 (15 – 20cm) with 5/8 (16mm) arbor
(For information contact your Target supplier)
Depths of Cut (Maximum):
2.00" with Ø 8"
Nominal Weight: 75 lb. (34 kg)
Operating Weight: 75 lb. (34 kg)
Dimensions (L x W x H):
Blade Shaft RPM: 8" (20cm) - 5400 Maximum
Before starting up machine make
sure you read these instructions and
are familiar with the operation of this
machine.
The working
completely clear, well lit and all
safety hazards removed (no water or
dangerous objects in the vicinity)
10
INDICATION
INFORMATION
our factory every
17" x 13" x 26" (43 x 33 x 66 cm)
area must
The operator must wear
protective clothing
appropriate to the work
he is doing.
recommend hearing,
respiratory and
protection.
Any persons not involved in the work,
should leave the area.
Use only blades marked with a maximum
operating speed greater than the
bladeshaft speed.
2.
General Instructions
•
Use ONLY general purpose dry cutting diamond
blades intended for use on power saws - speed
rate at 5000RPM or higher, maximum 8 (20cm)
diameter.
WARNING: This saw is intended to
operate with dry cutting diamond blades
with a 5/8 (15mm) diameter arbor ONLY.
•
Always turn the engine off prior to mounting,
removing or changing blades or adjusting the
guard, guide frame or other accessories.
•
Make sure that both blade flanges are clean and
free from burrs and/or foreign matter. Do not use
flanges that are worn down in diameter or of
uneven diameter. Tighten flanges securely with
the special clamping nut and wrench provided.
Rotate the blade by hand to be certain that it does
not come in contact with the blade guard.
•
To mount cutting blade, release the blade guard
latch and rotate the blade guard until the blade
flanges are accessible. Place the inner flange over
the shaft bushing and make sure the flange fits flat
against the shaft bushing. Next inspect the blade
and hole and assure that it fits snugly over the
shaft bushing.
tighten securely with a 9/16
the blade guard and relatch.
•
To aid tightening the flange nut, there is a 1
(2.54cm) hex wrench provided for holding the shaft
be
bushing.
blade flanges.
•
Frequent cleaning and care will allow the saw to
run cooler and provide longer service. The saw is
most effectively cleaned with dry compressed air.
Do not use a high pressure washer around the
blade shaft bearing seals, switch assembly or
We electric motor components.
eye
Install the outer flange nut and
hex wrench. Lower
Do not over tighten as to deform the