Fitting And Removing The Battery Pack; Battery Charging; To Obtain The Best Life For The Battery - Global Machinery Company GTX181HR Manual Del Usario

Fitting and removing the battery pack

To remove the battery pack from the drill firmly press the
battery release tabs (7) at either side of the battery pack,
and slide the battery backward out of the tool.
To install the battery pack, align
rails, on the tool with the tabs
on the battery pack and slide
the battery pack on to the drill.
Ensure the battery pack is sitting
straight on the foot and correctly
entering the runners. The battery
should slide fully on to the drill
foot until the battery pack "clicks"
into position.

Battery charging

1. Connect charger (9) to power
source. The green light (a),
should light up. This indicates
the charger is ready to begin
charging.
2. Position battery pack on
charger, align rails (d), on
battery charger with (e) on
battery pack. Slide battery
forward onto charger until it
clicks into position.
e
3. The red light (b), should
4. After approximately one hour,
5. To remove the battery pack from the charger depress the
WARNING. Do not leave batteries charging for longer than
a b
24 hours.
Note. Depending on room temperature, line voltage, and
existing charge level, initial battery charging may take longer
than one hour.
Note. Disconnect charger from power source when not in use.

To obtain the best life for the battery

Never allow the drill to come to a complete stand still
before recharging. The battery should be placed on charge
whenever the battery is noticeably running down or the drill
no longer performs a task it previously performed.
Avoid conducting short charges. Make sure that the battery
is fully charged every time by allowing the charger to
complete its full charging cycle.
d
Avoid allowing lose items like screws or nails etc. to be
stored with battery packs as these or similar items can short
battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in a
dry secure place.
Avoid charging or storing your battery in temperatures below
0ºC and above 40ºC.
9
begin to glow continuously,
indicating that the battery pack
is receiving a "Fast Charge".
the "Fast Charge" indicator
red light (b) should go out
indicating that the battery pack
is fully charged and that the
charger is now in a "Maintenance Charge" mode, this
is confirmed by the green light (a) coming back on. The
battery pack can be left on Maintenance Charge" until
you are ready to use it.
battery pack release buttons (7) and slide the battery off.
GB