Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Type 3
Step1: Remove the top cover, and find where to install a hard disk on the recorder.
Step2: Get a compatible hard disk. With the PCB side facing down, find the screw holes on the recorder base, and
place the hard disk in the recorder.
Note: To use a green hard disk, use ONLY the hard disk designed especially for surveillance to ensure the
device works properly.
Step3: Connect the data bus and power cable for the hard disk.
Step4: Align the screw holes on the base and the hard disk. Then, fasten the hard disk o the base with the supplied
screws from the bottom side of the recorder.
Step5: Replace the top cover and fasten the screws you loosened in Step1.
Step6: Remove the protective film on the bottom of the recorder if any to ensure the heat dissipation can work
normally.
4
Tabla de contenido
