Power Indicator; Cold Weather Operation - Flex FX0111 Manual Del Operador

WARNING
product damage due to a short circuit, never
immerse your charger or battery pack in
fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.

POWER INDICATOR

This lithium-ion battery pack is equipped with
power indicators on both sides of the battery
pack that display the battery charge
Press the power-indicator button on the front
of battery pack to display the four LEDs in the
power indicator. The LEDs will remain lit for
LOW CAPACITY WARNING
If one LED on the power indicator begins to
flash, the battery pack charge is under 10%
capacity and should be recharged. Unlike other
types of battery packs, lithium-ion battery packs
deliver fade-free power for their entire run time.
The tool will not experience a slow, gradual loss
of power as it is used.The power delivered to
OVER-TEMPERATURE WARNING
The battery circuitry also protects the battery
pack from overheating. To protect the battery
pack from damage and prolong its life, the
battery pack circuitry will send a warning signal
to the tool if the temperature becomes too high
during use. The first and third LEDs on the

COLD WEATHER OPERATION

When the battery pack is very cold, the
performance may be weakened. Put the
battery pack on a tool and use the tool in a
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
level.
WARNING
accessories not recommended for use with
this battery pack. Any such alteration or
modification is misuse and could result in a
hazardous condition leading to possibly serious
personal injury.
approximately 10 seconds. It is recommended
that the battery pack be reacharged to full
charge before starting a big job or using it for
long periods of time.
The power indicator can be used regardless
whether the battery is attached or removed from
tool.
the tool will drop quickly when the battery pack
is at the end of its run time and needs to be
charged. When the battery pack is completely
discharged or over-voltage, the power indicator
will begin to display four flashing LEDs.
When this happens, remove the tool from the
workpiece and charge the battery pack as
needed.
power indicator will rapidly flash green to warn
of the over-temperature condition. This may
happen in extremely high torque, binding, and
stalling situations. The battery pack will begin
normal operation after it has cooled down.
NOTICE: A significantly reduced run time after
fully charging the battery pack indicates that the
batteries are near the end of their usable life
and must be replaced.
light application for a while to "warm up" the
battery pack or place the battery pack in room
temperature until it has warmed. The battery
pack will operate normally.
-8-
Do not attempt to modify
the battery pack or create