Troubleshooting - CANDY HOOVER 177 Manual Del Usuario

For the product to operate correctly it is
essential to allow adequate air circulation so as
to cool down the condenser located in the rear
part of the appliance.
For this reason, the column must be equipped
with a rear chimney, whose upper opening must
not be blocked and with a front slot which will
be covered with a ventilation grill.
SUSPENDING USE OF THE
APPLIANCE
If the appliance is not to be used for a long
time:
1) Turn the appliance OFF (see Operation).
2) Extract the plug or remove the safety device.
3) Clean the appliance
4) Leave the doors of the appliance open.

TROUBLESHOOTING

PROBLEM CAUSE
The The doors are
refrigerator not closed.
and freezer do The doors are
not sufficiently frequently
cool. opened
Erroneous
setting of the
temperature.
The
refrigerator
and freezer
have been
excessively
filled.
Surrounding
temperature is
too low.
No electrical
power.
The motor The doors are
runs not closed.
continuously. The doors are
opened
frequently.
Ambient
temperature is
very high.
Thickness of
frost than
3mm.
The frozen The ambient
food is temperature
thawing. range below
climate class of
the product.
The
compressor
starts rarely
The freezer
door is not
closed.
IF YOU ARE NOT SOLVED THE PROBLEM,
CONTACT THE SERVICE CENTER, PLEASE GIVE
THE TYPE OF FAULT AND THE INFORMATION
REMEDY
Check that the
door and gaskets
close properly.
Avoid unnecessary
opening of the
doors for a period
of time.
Check the
temperature
setting and, if it is
possible, cool even
more (see
Temperature
adjustment)
Wait for the
stabilization of the
temperature of the
refrigerator or
freezer.
Check that the
ambient
temperature is in
accordance with
what is indicated
on the nameplate
(see Installation).
The power cord is
not properly
plugged in.
Check whether the
appliance is
switched off (see
Temperature
adjustment)
Ensure that in the
home there is
current.
Make sure the
doors are closed
and if the seals
close properly.
Avoid unnecessary
open ports for a
certain period.
Verify that the
ambient
temperature is in
accordance with
the specifications
on the nameplate
(see Installation).
Set the
display/thermostat
a warmer
temperature.
Defrost the unit
(see Defrosting).
Move the unit to a
warmer or heat
the room.
Make sure the
door is closed and
that the gasket
is sealing properly.