Philips DLP2103/37 Manual De Instrucciones
Philips DLP2103/37 Manual De Instrucciones

Philips DLP2103/37 Manual De Instrucciones

Cargador portátil
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Battery Pack
DLP2103/37
User manual
WARNING: RISK OF FIRE AND SHOCK
RISK OF FIRE
• AVOID PLACING THE USB BATTERY PACK IN DIRECT SUNLIGHT, NEAR A
HEATER, OR OTHER LOCATIONS OF EXTREME TEMPERATURES.
• DO NOT CONTINUE USING OR ATTEMPT TO CHARGE THE USB BATTERY PACK IF IT HAS
BEEN PUNCTURED, CRUSHED, DEFORMED, DAMAGED, OR IF IT EXHIBITS ANY ABNORMAL
CHARACTERISTICS SUCH AS EXCESSIVE HEATING, SWELLING, OR IF IT EMITS AN ODOR.
• USE ONLY IN DRY LOCATIONS. NEVER IMMERSE THE UNIT IN LIQUIDS.
• DO NOT OPERATE THE USB BATTERY PACK NEAR
FLAMMABLE MATERIALS, FUMES OR GASES.
• USE ONLY A USB POWER SUPPLY WITH A 5.0V OUTPUT OR
COMPUTER USB PORT TO CHARGE THE USB BATTERY PACK.
• DO NOT OPEN THE USB BATTERY PACK. THERE ARE NO USER SERVICABLE PARTS.
• TO AVOID AN EXPLOSION OR EXPOSURE TO TOXIC FUMES,
DO NOT DISPOSE OF THE USB BATTERY PACK IN A FIRE.
• USE A MILD SOAP AND WATER SHOULD THE BATTERY
CONTENTS COME INTO CONTACT WITH THE SKIN.
• RINSE EYES WITH CLEAN RUNNING WATER SHOULD THE BATTERY CONTENTS
COME INTO CONTEACT WITH THE EYES AND SEEK MEDICAL ATTENTION.
• KEEP AWAY FROM CHILDREN. THE USB BATTERY PACK IS NOT A TOY.
• DO NOT DROP THE USB BATTERY PACK.
Thank you for purchasing your new USB Battery Pack. Its convenience
and practicality make it ideal for travel. No matter where you are or
where you are going, take this battery pack on the go. Easily charge your
smartphones, tablets, smartwatches and other mobile devices anytime
and anywhere.
Package Contents
USB Battery Pack
Micro USB Charging Cable
Instruction Manual
Fuel Gauge
Press the power button on the USB Battery Pack to see battery level.
Charging the USB Battery Pack
When the battery pack needs to be recharged, insert the provided
Micro USB cable into the Micro USB charging port on the battery pack.
Insert the opposite end of the USB cable into a USB power source.
When the battery pack is fully charged, all 4 LEDs will illuminate.
Charging Your Device
Plug the USB-A end of your cable into the battery pack and the
other end into your device. Once the device is connected, press
the power button on the battery pack and charging will begin.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Such modifications could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Battery Disposal
The USB Battery Pack contains a lithium polymer battery. Follow all
applicable state and federal laws for battery disposal and recycling.
Do not dispose of the USB Battery Pack in the garbage. Take it to your
local battery recycling center.
MADE IN CHINA
The Philips trademark and the Philips Shield Emblem
are registered trademarks of Koninklijke Philips
N.V. used under license. This product has been
manufactured by Gibson Innovations Limited. It is
distributed and warranted by Jasco Products Company
LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114.
©2018 Gibson Innovations, all rights reserved.
This product comes with a limited-lifetime warranty.
Visit www.philips.com/support for warranty details.
Questions? Contact us at 1-844-816-0320
between 7:00AM—8:00PM CST.
DLP2103/37 v1
11/17
loading

Resumen de contenidos para Philips DLP2103/37

  • Página 1 Instruction Manual MADE IN CHINA FCC Statement The Philips trademark and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. used under license. This product has been This device complies with Part 15 of the FCC rules. Operation is subject to the manufactured by Gibson Innovations Limited.
  • Página 2 HECHO EN CHINA Declaración de la Comisión Federal • Manual de instrucciones La marca Philips como el emblema de escudo Philips de Comunicaciones (FCC) son marcas registradas de Koninklijke Philips N.V. y son utilizadas bajo licencia. Este producto ha sido fabricado Botón de...