Tabla de contenido
TO TURN ON
• Connect the soldering iron to the electric current.
OPERATION
1. Clean surfaces to be solded, if possible,
without damaging roughen with a wire brush or
sandpaper. Use alcohol to remove oil or grease.
CAUTION: Do not use any other type of solvent,
to avoid risk of fire and toxic fumes.
2. Heat the part to be welded
with the soldering iron.
3. Apply resin-based solder to
the part previously heated,
immediately
apply
the
soldering iron to melt the
solder.
NOTE:
When
using
non-resin-based solder, be sure
to apply a solder paste to the
pre-heated part before placing
the soldering iron.
4. Wait for the solder to cool and harden before
moving the soldered part.
MAINTENANCE
CARE AND MAINTENANCE OF IRON TIP
IMPORTANT: It is recommended not to exceed
two minutes of continuous work, to avoid
shortening its life.
CLEANING
The iron tip must be cleaned after use, wiping
the tip on a cleaning sponge, this is to get rid of
the residue of solder that can cause oxidation of
the tip. If the tip has a bit of rust, apply solder
and wipe with sponge, repeat these steps until
you remove the oxidation.
Tabla de contenido
