Lcd Screen Safety Instructions; Memory Card Safety Instructions - Epson XP-431 Instrucciones De Seguridad Importantes

■
Do not touch the flat white cable and ink tubes inside the product.
■
Do not move the print head by hand; this may damage the product.
■
Do not put your hand inside the product while it is printing.
■
Do not spill liquid on the product or use the product with wet hands.
■
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■
Do not press too hard on the scanner glass when placing originals.
■
Do not open the scanner section while the product is copying, printing, scanning, or
performing any other functions.
■
Be careful not to trap your fingers when closing the document cover or scanner unit.
■
Except as specifically explained in your documentation, do not attempt to disassemble or
service any part of the product yourself.
■
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
■
Before transporting the product, make sure that the print head is in the home (far right)
position.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak.

LCD Screen Safety Instructions

■
Use only a dry, soft cloth to clean the LCD screen. Do not use liquid or chemical cleansers.
■
The LCD screen may contain a few small bright or dark spots, and because of its features it may
have an uneven brightness. These are normal and do not indicate that it is damaged in any way.
■
The exterior cover of the LCD screen could break if it receives a heavy impact. If the LCD
screen gets damaged, contact Epson. If the liquid crystal solution gets on your hands, wash
them thoroughly with soap and water. If the liquid crystal solution gets into your eyes, flush
them immediately with water. If discomfort or vision problems remain after a thorough
flushing, see a doctor immediately.

Memory Card Safety Instructions

■
Use only compatible memory cards (see the User's Guide for a detailed list).
■
Do not remove a memory card or turn off the product while the memory card light is flashing.
Important Safety Instructions
11