Vacuuming Dry Materials; Vacuuming Liquids - Bucket Head BH01000 Manual Del Usuario

Vacuuming Dry Materials

1. It is very important to assemble the
filter to the cage without allowing any
possible leaks or tears. Any leaks will
allow the media being picked up to be
blown out of the blower port and back
into the surrounding environment.
See "Replacing the Filter" in the
Maintenance section for complete
details.
2. To maintain peak performance of your
Vac when picking up small debris such
as sawdust, it may be helpful to empty
the bucket and replace the filter at
more frequent intervals.
NOTE: The filter should be dry to pick up
dry material. If you use your Vac to pick
up dry debris when the filter is wet, the
filter will clog quickly. If the filter gets wet,
replace it before continuing dry pickup.
OPERATION
Filter
Rib Tab
Retainer
Band
Lid
(continued)

Vacuuming Liquids

1. Removal of the filter is recommended
for wet pickups.
2. This Wet/Dry Vac is equipped with a float
mechanism which will rise automatically
to cut off the airflow when the liquid in
the drum reaches a predetermined level.
When this happens, turn off Vac, unplug
the power cord, and empty the bucket.
You will know that the float has shut the
airflow off because the suction ceases
and the motor noise becomes higher in
pitch, due to increased motor speed.
The liquid capacity may vary with the
rate of pickup.
3. If a filter was used for wet pickup, be
sure to replace filter after wet pickup.
Never pick up dry debris without the
filter properly installed.
6
Float In
Raised
Position